MESSKO® IgT-MU
Signal conditioner
The IgT-MU measuring transducer is used to transform and galvanically isolate direct current or direct voltage into an impressed direct current and direct voltage signal. The calibrated double outputs can be switched between 0–20 mA and 0–10 V or between 4–20 mA and 2–10 V. It is installed in the control cabinet using 35 mm cap rails.
Your Advantages at a Glance
-
Direct current measuring transducer
Product Information
| Input variable | Direct voltage or direct current |
| Rated values | from 0-5 mV to 0-600 V, Ri = 100 kOhm/V, max. 2 MOhm |
| Outputs | 0-20 mA/0-500 Ohm load and 0-10 V max. 10 mA load as well as 4-20 mA/0-500 Ohm load and 2-10 V max. 10 mA load, switchable on front side |
| Accuracy | +/- 0,5% of full scale |
| Response time | < 300 ms (with frequency module < 400 ms) |
| Operation temperature | -15 to +20 to +30 to +55 °C |
| Storage temperature | -25 - 85 °C |
| Temperature influence | < 0,1% at 10 K |
| Ambient conditions | No stationary application, weather protected, rel. air humidity 5 - 95%, no condensation, altitude up to 2000 m, water, rain, snow or hail excluded |
Select language
Please make a selection to display suitable downloads
Technical Data
| Input variable | Direct voltage or direct current |
| Rated values | from 0-5 mV to 0-600 V, Ri = 100 kOhm/V, max. 2 MOhm |
| Outputs | 0-20 mA/0-500 Ohm load and 0-10 V max. 10 mA load as well as 4-20 mA/0-500 Ohm load and 2-10 V max. 10 mA load, switchable on front side |
| Accuracy | +/- 0,5% of full scale |
| Response time | < 300 ms (with frequency module < 400 ms) |
| Operation temperature | -15 to +20 to +30 to +55 °C |
| Storage temperature | -25 - 85 °C |
| Temperature influence | < 0,1% at 10 K |
| Ambient conditions | No stationary application, weather protected, rel. air humidity 5 - 95%, no condensation, altitude up to 2000 m, water, rain, snow or hail excluded |
Downloads
Select language
Please make a selection to display suitable downloads
